This is the MPLAB software is very important to use or doing simulation. It related each other. To do simulation for circuit and programming, I use proteus software. For command or programming we use MPLAB software ant to burn into pic we use software pic kit. And the picture below show the result of my program Automatic Accident Alert System.
Picture below show the demonstrate how to burn the IC of PIC 16877A program into the PIC burner. Below is the step :-
1) Now WinPic800 is ready to program the PIC. This programmer is able to detect the PIC. By clicking the icon shown, the programmer will detect the type of PIC on the programmer.
2) To write Hex code to PIC we must first open the hex file. By clicking the icon shown, a browse window will appear, open the hex file by clicking the file.
3) Program the file to PIC by clicking the icon shown.
4) A confirmation window will appear, click Yes to proceed programming PIC.
5) When it is completed, the window will show the status. Click Accept and the PIC is ready to be plug out.
6) To disconnect UP00A, simply plug the USB out. No extra configuration or setting needed. Same applied when plug-in for the 2nd time, installation of driver is not required.
copyright by
sh mohd faiz
No comments:
Post a Comment